Schneider Electric Xantrex XW Instalační příručka stáhnout pdf (Strana 39)

Installing the Battery Temperature Sensor

975-0540-01-01 Revision B 2–21

This guide is for use by qualified personnel only.

4. Pass the other end of the BTS cable through the knockout and strain relief

bushing on the charge controller, and then insert the BTS plug into the BTS

RJ-11 port. See Figure 2-15.

5. Replace the charge controller’s wiring compartment cover.

Figure 2-14 Attaching the BTS to a battery terminal

WARNING

HAZARD OF ELECTRIC SHOCK

The BTS cable must not pass through the same conduit used for PV wiring and

battery cables.

Failure to follow these instructions can result in death or serious injury.

Figure 2-15 Installing the BTS

–

Insert the BTS plug into

the charge controller’s

BTS port.

Attach the BTS to a

battery terminal or to

the side of a battery.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 61 62

Žádné komentáře

Schneider Electric Xantrex XW Instalační příručka Strana 39