Schneider Electric Modbus Plus Network Bridge Multiplexer none Instalační příručka stáhnout pdf (Strana 240)

228 Installing Custom Cable Systems

890 USE 100 00

You will also need to know which type of network device (type of

Modicon 984 controller or other device) is to be installed at each point

on the cable. The connector wiring direction will depend on the type of

device installed.

D .7.2 Overview of the Connector Installation

Each connector requires six kinds of action:

V Preparing the cable

V Identifying the connector terminals

V Connecting the wires

V Inspecting the connection

V replacing the cap

V Completing the connection

D .7.3 Preparing the Cable

Remove 3 in (7.5 cm) of the cable’s outer jacket and shields as shown in

Figure 98 below. This will expose the cable’s two signal wires and drain

wire.

Strip approximately 1/4 in (6 mm) of the insulation from the end of

each signal wire. This will allow you to check wiring continuity to the

connector’s pins.

3.0 IN (7.5 CM)

0.25 IN

(6 MM)

Figure 98 Preparing the Cable

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 260 261

Žádné komentáře

Schneider Electric Modbus Plus Network Bridge Multiplexer none Instalační příručka Strana 240