Schneider Electric Splitter Boxes Technické informace stáhnout pdf (Strana 178)

CANopen TeSys U Motor Control Devices

178

31006709 2/2009

Assembly of a TeSys U Motor Control Device

Introduction

The CANopen TeSys U motor control devices can be assembled with a variety of

components to makeup a final configuration of a motor-starter controller or motor

controller. For the purpose of this discussion, we are concerned with the general

makeup of a motor-starter controller consisting of the three components

(see page 175) described previously.

 power base

 control unit

 communication module

Once you have selected a power base and control unit for your specific application,

along with a LULC08 CANopen Communication Module, you can proceed according

to the following general instructions.

The LULC08 DIP Switches

Prior to installing the LULC08 CANopen Communication Module into the TeSys U

power base, unit you need to set the baud rate and node ID address with the DIP

switches located on the bottom of the module.

A bottom view of a LULC08 communication module is shown below:

1 CAN bus connector

2 baud rate

3 node ID address

4 power base connector

5 logic input, output & power connector

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 315 316

Žádné komentáře

Schneider Electric Splitter Boxes Technické informace Strana 178