Schneider Electric ALTIVAR 58 TRX Instalační příručka stáhnout pdf (Strana 17)

VVDED397047USR6/03 Chapter 1—Overview

06/2003 Keypad Display

9. Configure the fault management parameters in the 6—Fault

menu.

10. Make Communication or Application configurations (if one of

these options is used).

11. Configure the settings in the 2—Adjust menu.

NOTE: You must ensure that the functions which are programmed

are compatible with the control scheme used.

Minimum Start-Up

This procedure can be used as a minimum start-up:

• In simple applications where the drive controller factory settings

are sufficient

• In installations when it is necessary to turn the motor before fully

completing the start-up sequence

Procedure:

1. Make sure that the 50/60 Hz switch is in the correct position,

corresponding to the frequency of the incoming AC power, as

shown on page 14.

2. Ensure that the macro-configuration factory setting is suitable for

the application. Refer to Table 3 on page 24. If not, change the

configuration in the Macro-Configuration menu as shown on

page 25.

NOTE: 125-500 hp drive controllers have only the variable torque

macro.

3. Verify that the control scheme is compatible with the macro-

configuration, ensuring that the necessary safety precautions

have been taken. Refer to the drive controller instruction bulletin,

VVDED397048US, for a typical wiring diagram.

4. Verify in the 3—Drive menu that the factory settings are

compatible with the motor nameplate values. Refer to Table 11 on

page 43. Modify them to match the nameplate values.

5. If necessary, adjust the parameters in the 2—Adjust menu

(ramps, motor thermal protection, etc.). See Table 6 on page 30.

If the Freewheel Stop/Run Permissive function is assigned to a

logic input, the drive controller will not start the motor unless

that logic input is connected to +24 V.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 125 126

Žádné komentáře

Schneider Electric ALTIVAR 58 TRX Instalační příručka Strana 17