
© 1998–2003 Schneider Electric All Rights Reserved
VVDED397047USR6/03 Chapter 2—Menus
06/2003 7—Files Menu
93
NOTE: Menu access allowed by the locking switch setting can be
limited by the access code.
The access code is set by using the and keys. Press ENT
twice to validate the code you have chosen. The display reverts to 0
indicating the password has been accepted. The menus are now
locked and your access code must be entered to unlock them. If an
incorrect code is entered, it is refused, and the following message is
displayed:
After pressing ENT or ESC on the keypad display, the user can try to
reenter the correct code.
To access the menus protected by the access code, the correct code
must first be entered in the File menu. The File menu is always
accessible. Once the correct code has been entered, press ENT and
then press ESC twice to get to the menu tree. Display and
modifications are now allowed per the code entered.
After completing your changes, cycle power or remove the keypad to
re-lock access to the menus.
Menu 8 will only appear on the keypad display if a communication
option card or application option card has been installed in the drive
controller. Communication option cards contains drivers and
connection points for integration into various industrial and building
automation networks. Application option cards expand the I/O
Table 24: Significance of Access Code Last Digit
Menus Affected:
Access is
locked
if last digit of
code is:
Display is
allowed
if last digit of
code is:
Modification
is allowed
if last digit of
code is:
2 0
[1]
or 9 1 2
2, 3, 4, 5, 6, 7, 8, and Macro-
Configuration
0
[1]
or 9 3 4
8 0
[1]
or 9 5 6
2, 3, 4, 5, 6, 7, 8 0
[1]
or 9 7 8
[1]
If the factory setting, 0000, is used, access to the menus is completely
unlimited.
Figure 23: Incorrect Code Display
Password Fault
Err
Komentáře k této Příručce